Boże Narodzenie
Zamów przed 18. gru  -  Więcej informacji
×
Menu

Alpinist U-Bow

(10)
1 para
Ilość
1 para
2 pary
3 pary
4 pary
Limited quantity available
Ilość
1 para
2 pary
3 pary
4 pary
5 par
6 par
7 par
8 par
9 par
10+
Dodaj do koszyka
  Zapisz na później
Darmowa wysyłka od 349 zł
Dostawa 2-4 dni robocze
365 dni na zwrot

Opis

Alpinist U-Bow od firmy Marker do wiązań pin tech.

Wybierz ten element w różnych twardościach.

  • Miękki = Około 5.5DIN
  • Średni = Około 8DIN
  • Twardy = Około 11DIN

Specyfikacja modelu

ModelWaga
Medium35g
Hard40g

Specyfikacje

Przeznaczenie:
Touring
Pokaż wszystkie

Opinie   (10)

Zweryfikowany kupujący
"Sprawnie i szybko załatwione"
Maria Głowacka (Zabrze) 03/02/2020
Zweryfikowany kupujący
"Quick delivery from the US to Canada and exactly as ordered. Flawless shopping experience! My tip to install, use a fairly big set of those quick adjust pipe wrench that opens to 2” gap or so. Just press them into position and use them to get the old ones half way out. Easy peezy."
Flavelle Scott (Mount Currie) 27/01/2021
Zweryfikowany kupujący
"The Marker U springs arrived faster than expected, and are exactly as advertised."
Kenneth Linden (Irvine) 19/01/2021
Zweryfikowany kupujący
"Completely agree with Karol below. Nightmare to install. Had to file the inner edge a bit to get them on, after various failed attempts started to chew up the plastic/carbon body of the binding. The cut ends of the springs are pretty unrefined and could do with a bit of filing before they leave the factory. Once on, they work fine, I'm sure, and I got a swift and sensible reply from Skatepro when I asked for advice, so overall a positive experience. Would certainly use this retailer again."
Archie Gillies (Aberdeen) 12/11/2020
Zweryfikowany kupujący
"Have not had a chance to test them, not enough snow yet, but have no reason to believe they would not work. Got them to replace the "hard" DIN 12 bows that came with my bindings. They certainly were a bitch to install though. Not like the manufacturer describes it, just remove the small screw and slide it out/slide it in. The prongs are not quite parallel but rather convergent a bit. At the end I managed to spread them a little by forcing a suitable size of a socket wrench in between of them."
Karol S. (Northport) 28/10/2019
Pokaż wszystkie 10 oceny
SkatePro